:set-register

Arguments: name value

This command sets the value of the specified register to value, which is evaluated. The register is identified by name. :register shows the current value of a register.

The minimal abbreviation of :set-register is :set-r.

This command operates on the focused process when multiprocessing is active. See :focus.

See top-level.htm for more information on top-level commands. See debugging.htm for information on the debugger.

Copyright (c) 1998-2022, Franz Inc. Lafayette, CA., USA. All rights reserved.
This page was not revised from the 10.0 page.
Created 2019.8.20.