:set-local

Arguments: [:i] [:c] [:r] [name|index] value

This command sets the value of the specified local variable to value, which is evaluated. The local variable is identified by name if interpreted, or name or index if compiled. :local shows the current value of a local.

The :r option cause the :local command to display locals in raw mode. It can be used with this coomand to set raw values (by index, as names are not displayed in raw mode. See :local for more information on the option.

The minimal abbreviation of :set-local is :set-l.

This command operates on the focused process when multiprocessing is active. See :focus.

See top-level.htm for more information on top-level commands. See debugging.htm for information on the debugger.

Copyright (c) 1998-2019, Franz Inc. Oakland, CA., USA. All rights reserved.
This page was not revised from the 9.0 page.
Created 2015.5.21.