Generic FunctionPackage: ideToCDocOverviewCGDocRelNotesFAQIndexPermutedIndex
Allegro CL version 10.0
Unrevised from 9.0 to 10.0.
9.0 version

open-files-in-gnu-emacs

Arguments: configuration

The value of this configuration property can be nil, :open-only, or any other true value. If this configuration property is true and the Emacs-Lisp Interface is running, then the IDE will open lisp source code files in GNU emacs. Otherwise it will open them in the IDE editor. The :open-only value affects the behavior of File | Save All menu command, as described below in a way different from its modified behavior when this propert is true but not :open-only. This property affects the following commands:

When this option is enabled, the IDE's File | Save All command will tell Emacs to save all of its modified buffers (in addition to Save All's usual functionality). As a special case, if the value of this option is the keyword :open-only, then the IDE will open files in Emacs but never tell emacs to save modified buffers.

A check box for this configuration property is located on the Editor tab of the Options dialog.

The property is off by default. The special value :open-only cannot be specified on the Options dialog, but it could be set by evaluating the following form:

(setf (ide:open-files-in-gnu-emacs (cg:configuration ide:*ide-system*))
      :open-only)

open-files-in-gnu-emacs is a property of the configuration class.


Copyright (c) 1998-2019, Franz Inc. Oakland, CA., USA. All rights reserved.
This page was not revised from the 9.0 page.
Created 2015.5.21.

ToCDocOverviewCGDocRelNotesFAQIndexPermutedIndex
Allegro CL version 10.0
Unrevised from 9.0 to 10.0.
9.0 version