| Allegro CL version 10.0 Unrevised from 9.0 to 10.0. 9.0 version |
Arguments: chart-or-plot
Returns the value of the extend-data-to-middle-of-border property of
a chart-or-plot
. The value
may be set at creation time by passing
the :extend-data-to-middle-of-border
initarg, or
any time later by calling (setf
extend-data-to-middle-of-border).
A boolean value indicating whether the data area of
a chart-or-plot
extends to
the middle of the body border rather than only to the inner edge of
the body border. This choice is a subtle trade-off in the aesthetics
of how a chart is drawn, where neatly aligning end tic marks with axes
means that data will extend into the middle of a thick axis. The
default value is t
for just that choice.
This property matters most when a chart body border is thick, and is best described by example. Let's assume that the chart-orientation is :vertical (meaning that the value axis is vertical), that the axis-width of the horizontal item-axis is 7, that the range-bottom of the value-axis is zero, and that a data value of zero is being plotted.
In this example, if extend-data-to-middle-of-border
is nil
, then a line that is drawn downward to
the zero data point will be drawn just to the top of the thick
item-axis along the bottom of the chart. Any icon for the zero data
point will be centered at the top of the thick item-axis line as well.
If this property is true instead, then the line will extend four
pixels farther downward to the middle of the thick item axis, and any
icon would be centered about the middle of the axis.
A thick tic mark on the vertical value axis will always be vertically
centered about the data value to which it points. So if the value of
this property is nil
, then a thick tic mark
at the bottom of the value axis will appear jogged upward from the
horizontal item-axis a bit so that its center is aligned with the top
of the item-axis, because that is where a data value of zero is
plotted. That tends to look a bit sloppy, so the default value of
this property is true to instead align a thick end tic mark exactly
with an axis of the same thickness. The trade-off is that this causes
data values to extend to the middle of the item-axis, which may
obscure the data somewhat.
See chart-widget
and also cg-chart-widget.htm.
Copyright (c) 1998-2019, Franz Inc. Oakland, CA., USA. All rights reserved.
This page was not revised from the 9.0 page.
Created 2015.5.21.
| Allegro CL version 10.0 Unrevised from 9.0 to 10.0. 9.0 version |