| Allegro CL version 8.2 Unrevised from 8.1 to 8.2. 8.1 version |
Arguments: (device mci-device) &key from to notify-p wait-p
Deletes all or part of the recorded sound in an mci-wave-audio
device. When
from and to are both nil
, this deletes the entire recording, which allows
mci-set-wave-options to again be
called on the wave device before recording to it again.
When either from or to is
non-nil
, it should be an integer indicating a
position in the recording. The value depends on the current time
format of the device; see mci-device-set-time-format and
tmsf-to-integer. Typically a value
to pass here was obtained by calling mci-device-position when playback
was paused at some position of interest. Specifying such positions
for both from and to allows editing out a small (or large) section of
an audio recording.
device is an mci-wave-audio
instance. If
wait-p is true, then this function does not
return until the operation is complete; otherwise the function returns
immediately and the operation is performed asynchronously. If
notify-p is true, then mci-notify is called when the
operation has completed.
See the sample recording session at mci-record for more information.
See cg-mci.htm for information about MCI support in Common Graphics.
Copyright (c) 1998-2016, Franz Inc. Oakland, CA., USA. All rights reserved.
This page was not revised from the 8.1 page.
Created 2010.1.21.
| Allegro CL version 8.2 Unrevised from 8.1 to 8.2. 8.1 version |