rpc-query

Arguments: (self rpc-port) (m rpc-message) &rest modifiers

This method is used with the message handle returned by rpc-invoke to query the state of a remote call. The value is a keyword that describes the state of the message. The possible keywords are:

While a call is in progress:

• :rms-begin-invoke: a call has been initiated.
• :rms-arguments: the arguments to the call are being transmitted.
• :rms-invoke-sent: the entire call has been transmitted.
• :rms-invoke-confirmed: the call has been acknowledged by the remote host. This state appears only if the confirm argument of the port is non-nil.
• :rms-receiving-results: the results are arriving.
• :rms-result-received: all the results have arrived. This state appears only if the confirm argument of the port is non-nil.

While a call is completed:

• :rms-done: the results have been confirmed and the call has completed successfully.
• :rms-error-received: the call is completed, but the remote host is transmitting error information. This state appears only if the confirm argument of the port is non-nil.
• :rms-error: the call is completed, but the remote host signaled an error.
• :rms-throw: the call was cut short by a throw in the remote host.

See also rpc.htm for general information on the Remote Procedure Call utility in Allegro CL.

Copyright (c) 1998-2022, Franz Inc. Lafayette, CA., USA. All rights reserved.
This page was not revised from the 10.0 page.
Created 2019.8.20.