*jlinker-start-timeout*

This variable specifies the default value of the timeout argument to jlinker-init when the mode is :start-java. In the :start-java case, a small timeout value is appropriate since Java is expected to connect to Lisp almost immediately.

It may be appropriate to increase this value if a long delay is expected when Lisp starts another OS process. A smaller value will allow Lisp to respond sooner to a failure in starting the Java VM.

The initial value of this variable is 10 (meaning 10 seconds).

See jlinker.htm for more information on the jLinker facility.

Copyright (c) 1998-2019, Franz Inc. Oakland, CA., USA. All rights reserved.
This page was not revised from the 9.0 page.
Created 2015.5.21.