vk-pause

There are pre-defined constants corresponding to usually non-typable keys on the keyboard (see key-names). When a Lisp function calls for a virtual key argument, one of the pre-defined constants is suitable as an argument value. The word after the hyphen names the key, in this case the Pause key. See also vk-cancel, as that keycode is used when Pause/Break is pressed while either of the two control keys is held down.

Copyright (c) 1998-2019, Franz Inc. Oakland, CA., USA. All rights reserved.
This page was not revised from the 9.0 page.
Created 2015.5.21.