show-dialog-on-compiler-warnings

Arguments: configuration

If this configuration option is true, as it is initially, then a modal dialog is shown when any compilation warnings result from compiling source code files by using various IDE commands. (The dialog is not shown when there are no warnings.)

The dialog lists the warning messages and provides an OK button to proceed with loading the compiled file(s) and a cancel button to skip loading the compiled file(s). In addition, if the compilation is being done by Run | Run Project or Run | Run Form, then canceling the dialog will avoid running the form or project.

The commands affected are File | Compile (no Cancel button is shown since no files are loaded by this command), File | Compile and Load, Tools | Compile Project, Tools | Full Compile, Run | Run Project, and Run | Run Form.

If this option is nil, then no dialog is shown, the loading is never skipped (unless a compilation error occurs), and (in the case of Run Project and Run Form) the project or form is always run. Compilation warnings are printed to the Debug Window regardless of the value of this option.

This option can be set in the Optional Dialogs group on the IDE 1 tab of the Options dialog. It may also be set with setf and this function.

The current development configuration is the value of (configuration *ide-system*). (See configuration and *ide-system*.)

Copyright (c) 1998-2019, Franz Inc. Oakland, CA., USA. All rights reserved.
This page was not revised from the 9.0 page.
Created 2015.5.21.