Generic FunctionPackage: ideToCDocOverviewCGDocRelNotesFAQIndexPermutedIndex
Allegro CL version 9.0
Unrevised from 8.2 to 9.0.
8.2 version

handle-multiple-packages-in-buffer

Arguments: ide-configuration

This IDE configuration option specifies whether commands such as Tools | Incremental Compile and Tools | Incremental Evaluation will read source code in the correct package even when the editor buffer contains multiple in-package forms for different packages. This takes somewhat more time to locate the in-package form that is associated with an individual definition that is being compiled or evaluated, but is needed when a buffer uses multiple packages. The extra time may be substantial for a very large buffer.

The default value is true, so that the correct package is always used. If you usually edit very large files that each use only a single package, then you may want to set this option to nil to eliminate a delay with searching for multiple in-package forms.

This option can be found on the Editor tab of the Options dialog, and could be set programmatically with a form like this one:

(setf (ide:handle-multiple-packages-in-buffer
        (configuration ide:*ide-system*))
      nil)

Copyright (c) 1998-2015, Franz Inc. Oakland, CA., USA. All rights reserved.
Documentation for Allegro CL version 9.0. This page was not revised from the 8.2 page.
Created 2012.5.30.

ToCDocOverviewCGDocRelNotesFAQIndexPermutedIndex
Allegro CL version 9.0
Unrevised from 8.2 to 9.0.
8.2 version