Generic FunctionPackage: socketToCDocOverviewCGDocRelNotesFAQIndexPermutedIndex
Allegro CL version 9.0
Unrevised from 8.2 to 9.0.
8.2 version

send-to

Arguments: sock buffer size &key remote-host remote-port ipv6 scope-id

For datagram sockets you can't do normal Lisp stream I/O. The data is written to the socket using this function. buffer is a Lisp vector type and size is the number of bytes of data to send. remote-host and remote-port describe where to send the data. If they aren't given then the values saved when the socket was created with make-socket are used.

The ipv6 and scope-id keyword arguments are part of IPv6 support. ipv6 defaults to the value of *ipv6*. This keyword argument is passed on to lookup-hostname when resolving remote-host.

scope-id specifies the interface to use when sending IPv6 traffic to remote-host. If remote-host is specified and is an ipv6-address structure, its scope-id slot will be updated to the value of the scope-id keyword argument.

If scope-id is not specified, then the scope-id slot of the remote-host argument will be used. If remote-host is not specified or does not have a scope-id, then 0 will be used.

Method for file-datagram-socket

Arguments: (sock file-datagram-socket) buffer size &key remote-filename

The method for file-datagram-sockets is like the method for datagram sockets described above, except it is used for sockets within the address family :file.

The method for file-datagram-socket is unaffected by the IPv6 changes. file-datagram sockets are not internet sockets so they cannot use IPv6 (or IPv4) addresses.

See socket.htm for general information on sockets in Allegro CL.


Copyright (c) 1998-2012, Franz Inc. Oakland, CA., USA. All rights reserved.
Documentation for Allegro CL version 9.0. This page was not revised from the 8.2 page.
Created 2012.5.30.

ToCDocOverviewCGDocRelNotesFAQIndexPermutedIndex
Allegro CL version 9.0
Unrevised from 8.2 to 9.0.
8.2 version